As a Crown Point metal roof coating contractor, we inspect every metal building on your property and coat them in an order that keeps business moving.
Crown Point metal roof coating jobs often cover more than one roof: a shop, a warehouse, and an office sharing one lot.
One roof walk covers every building, and you get a single findings list ranked by condition. The roof with active leaks over stock or people goes first, even when it is the smallest.
Each building keeps its own system choice. A pitched warehouse might take acrylic while the flatter office roof beside it gets silicone, all under one schedule and one point of contact.
These four conditions decide the order buildings get coated on Crown Point properties.
Active Leaks
Uneven Aging
Shared Runoff
Yard Traffic
Several roofs on one lot, before and after a coating program.
Most Crown Point lots mix roof types, so these three systems come up most.
The big screw-down warehouse roof gets rust treatment, fastener and lap sealing, and a coating sized for its panel area.
Commercial metal roof coating
A flatter office roof with slow drains gets silicone, which handles the water that sits after storms.
Silicone roof coating
A pitched shop roof that sheds water quickly takes acrylic, scheduled for a mild, dry stretch.
Acrylic roof coatingSend the property address and how many buildings are involved. The roof walk covers all of them in one visit.
On multi-building lots, the five steps repeat roof by roof in the order set after the walk.
Every building on the lot gets walked, probed for wet insulation, and photographed. The findings are ranked so the worst roof is coated first.
Leaks over people or stock, rust level, and how each building is used set the sequence. You approve the order before work starts.
Washing, rust grinding, primer, and screw and lap sealing finish on one building before the gear moves to the next.
Coating passes go on to the specified thickness, checked by gauge, with extra attention where runoff from a taller roof lands.
A final walk of every roof confirms the work, and you get one record of what was done on each building.
Besides Crown Point, we coat commercial metal roofs in Merrillville, Schererville, Hobart, St. John, and Cedar Lake.
Outside these towns? Call us or send us a message.
What Crown Point owners ask, from cost to coating several buildings on one lot.
We do, on shops, warehouses, and offices across Crown Point. Each job opens with a check of rust, screws, seams, and drainage, then cleaning, primer, fastener and lap sealing, and the coating that matches the roof's slope and condition.
Coating runs about $2.50 to $4.00 per square foot, compared with about $5 to $8 per square foot to replace panels. On a property with several roofs, each building gets its own line, since rust, repairs, and access differ from roof to roof.
Yes, and it is one of the most common setups we see. One inspection covers every roof, the buildings get a set order, and the schedule keeps one building's work area free when you need it.
Right here. We cover Crown Point from Merrillville along with four other nearby towns, and the roof walk is scheduled around your hours. Call or send the address to get started.
Yes. System choice follows each roof's slope and drainage, so a pitched warehouse and a flat office on the same lot often end up with different coatings. The two are planned together so prep and coating days line up.
It can, with each building listed on its own line. You see the repairs, system, and range for every roof, so you can coat them all at once or spread them over two budget years.
Runoff from a taller roof lands hard on one spot of the lower roof and wears the coating and laps there faster. That spot gets a reinforced coat, and the gutter or scupper feeding it is cleared and resealed.
Send the address and the number of buildings, or start with a ballpark range.